_ v1.1 adapters QFP44 - tet ? isystem, april 2005 1/8 target cpu package: QFP44 body size: 10 mm x 10 mm pitch: 0.8 mm pod target layout: t_qfp64 can be used with: ? st72f561 pod note that adapter solutions stated in the document can be used only with listed pods. disregarding this warning may result in hardware failur e of the target and the emulation system. h available adapter parts (by ordering code): ? ia44tq-solder solder part, which is bein g soldered to the target. recommended (by tet) pcb footprint size (unit: mm) a b c d e k l 12 1.325 13.0 13.0 2.0 14.65 14.65
? isystem, april 2005 2/8 ia44tq-solder dimensions ? ia64p44st7-tq the ia64p44st7-tq adapter consists of two parts. in this document, they are named ia44tq- solder and ia64p44st7-fixed to simplify the asse mbly instructions. note that the ia64p44st7- fixed is not the ordering code. however, ia44t q-solder part can be ordered as a spare part under its name. ia44tq-solder ia64p44st7-fixed ? ia64p44tq-w-st
? isystem, april 2005 3/8 ia64p44tq-w-st the ia64p44tq-w-st represents flexible connection between the pod and the target.
? isystem, april 2005 4/8 flexible adapter ia64p44tq-w-st and ia44tq-solder are essential pa rts required to adapt the pod to the target QFP44 package. first, ia44tq -solder is soldered to the target and then the pod is connected via ia64p44tq-w-st. h assembly while assembling the adapter and connecting the pod to the target, pay attention to pin 1. improper use of the adapter or even incorrect adapter used with your particular pod can damage the emulation system and the target. 1. first, solder ia44tq-solder to the target pcb. 2. next, connect the ia64p44tq-w-st to the pod. 3. finally, connect the pod via ia64p44tq-w-st to the target. precaution must be taken after the pod is connect ed to the target. adapter parts may break due to the user carelessness.
? isystem, april 2005 5/8 fixed adapter the ia64p44st7-tq part is required to adapt th e pod to the target QFP44 package. first, the ia44tq-solder is soldered to the target and then the pod is connected via the ia64p44st7- fixed. h assembly while assembling the adapter and connecting the pod to the target, pay attention to pin 1 to prevent any damages of the hardware, which ma y result from in correct assembly. step 1 : solder the ia44tq-solder to the target pcb. step 2 : connect the ia64p44st7-fixed to the pod. step 3 : connect the pod to the target via ia64p44st7-fixed. it is recommended to use plastic posts (if shipped with the pod), to establish adequate mechanical stability. note that some precaution must be taken to the pod adaptation after the pod is connected to the target. otherwise, the part soldered down to the target may break off.
? isystem, april 2005 6/8 h dimensions (unit : mm) a b c d e f x y ia64p44st7-tq 56 x 56 17 x 17 7.5 3.5 13.5 21 12 1.325
? isystem, april 2005 7/8 notes:
? isystem, april 2005 8/8 notes:
|
